Prosthodontics
Prosthodontics - Bridges
The basic concept of modern restorative and reconstructive dentistry is to protect the remaining sound tooth tissue.
When missing tooth structure or teeth are replaced, minimal biologic risk should be involved to reestablish function and esthetics. The proven reliability and durability of complete-crown metal ceramics has made them the method of choice for posterior single tooth restorations and fixed partial denture (FPD). However, this restoration required considerable reduction of tooth structure.
Growing use of adhesive technique and preservation of dental tissues has greatly impacted on conservative tooth preparation design. The development of fiber-reinforced composite (FRC) technology and all-ceramic systems has opened the potential for fabrication of metal-free restorations with durability and good esthetics.
The reduced invasiveness of these resin-bonded FPDs makes them an appealing alternative to conventional preparations. This advantage is emphasized in cases where the residual dentition exhibits low caries activity.
Dentapreg™ PFU, thanks to its outstanding mechanical properties and variety of shapes and fiber architecture, allows to follow a minimum invasivity principle: the preparation for bridge retention will exclusively be determined by the shape and size of previous cavity.
Biomechanics of the Bridge Framework
Primary roles of bridge framework are:
- To carry the pontic
- To shift the load applied to pontic during mastication to abutment teeth.
The major portion of masticatory forces shifted by bridgework from pontic to abutment teeth acts vertically. Therefore the bridgework is subject to deflection. It creates compression in upper part of the structure and tension in lower part of the structure. This type of stress requires to put substructure (Dentapreg™ PFU strip) in the lower part of the bridge framework. There are also peeks of shear stress in the interproximal area between abutment teeth and pontic. In order to minimize these peeks it is recommended to form a small curvature with Dentapreg™ strip.
Typology of Bridges Made of Dentapreg™ PFU
Retentions
Extracoronal retentions:
- Complete crown
- Partial crown
Intracoronal retentions with reduced invasivity
- Onlay
- Inlay
- Slot
Extracoronal non invasive retentions
- Wing
- Splint (Rochette Bridge)
Symmetry of Retentions
- Bridge with one type of retention (uniform retention)
- Bridge with two types of retention (combined retention)
Durability
- Permanent bridges
- Semipermanent bridges
- Provisional bridges
Prosthodontics - Repair
Reasons of Fracture of Removable Dentures and Appliances
- Extreme loading during chewing process
- Long-time bending as a result of chewing process
- Failure on interphase between removable denture or appliance and resin teeth
- Fall down of removable denture or appliance
Repair of Cracked and Broken Removable Denture
- Removable denture service life extension
- Easy way of processing
- Ensure of patient comfort
Reinforcement of Removable Denture
- Increasing of removable denture mechanical properties
- Removable denture service life extension
- Easy way of processing
- Ensure of patient comfort
- More informations in
- Instructions of Use
- Dentapreg™SFM
- Dentapreg™SFU
- Dentapreg™PFM
- Dentapreg™PFU
- Dentapreg™UFM
- Dentapreg™PFUI
- Dentapreg™PINPost
- Where to buy?
Please continue to the list of Dentapreg™ distributors.
If you are not from listed country, you can order Dentapreg™
products via e-shop or you can send us your requirements by email: sales@dentapreg.com
