Basic Procedures in Short

Preparation of anatomical stress free posts with Dentapreg™ SFU or PFU always involves several basic procedures repeated in all particular clinical situations:

Click on required picture for 3D view

1. Clean the root canal
 2. Measure the length of the required Dentapreg™ SFU or PFU
 3. Apply adhesive system
4. Cut the Dentapreg™ SFU or PFU to required length
 5. Insert Dentapreg™ SFU or PFU to root canal
 6. Light pre-cure the Dentapreg™
SFU or PFU
7. Remove Dentapreg™ SFU or PFU from the root canal and light cure it
 8. Apply dual curing cement on cured Dentapreg™ SFU or PFU
 9. Insert Dentapreg™ SFU or PFU to the root canal
10. Clean the overflowing cement in the flaring area
 11. Light cure the cement
 12. Final solution of Dentapreg™
SFU or PFU

Building the post with Dentapreg™ PINPost always involves several basic procedures repeated in all particular clinical situations:


Click on required picture for 3D view


1. Clean the root canal 2. Apply adhesive system
3. Light cure adhesive system




4. Cement root canal

and Dentapreg™ PINPost

 5. Insert Dentapreg™ PINPost(s) into the

root canal

 6. Remove overflowing

cement



7. Light cure the cement 8. Build the core
9.  Cut the Dentapreg™ PINPost(s)

to required length

General Remarks for Working with Dentapreg™

  • Endodontic block is a good training tool for trials of Dentapreg™
  • Before forming Dentapreg™ strip on a model, always apply separation liquid or wax
  • Always use the widest clinically acceptable Dentapreg™ strip
  • During forming and adaptation of the Dentapreg™ strip advance slowly from one end to the other to allow for a good adaptation of the fibrous reinforcement and small flow of the resin to avoid defects and shape memory effect
  • In order to minimize potential damage to the fibers, it is recommended to use plastic instruments for dental composites
  • When preparing the strip (measuring, trimming), keep the strip in its original transparent protection foil to avoid contamination
  • Avoid sharp edges and extremely small interproximal curvatures when forming Dentapreg™ strips to prevent fiber breakage
  • Most commercially available light or dual curing dental adhesives can be used to bond Dentapreg™ strips
  • Adhere according to the acid etching and adhesive  procedures recommended by the manufacturer of etching agent and adhesive

top 


  • International
  • Doctors and Technicians
  • Endodontics
  • Procedures
  • Basic Procedures in Short